HumiSeal® UV40 Gel

Video

HumiSeal® UV40 Gel is a single component, high solids, UV curable gel. A secondary moisture cure mechanism will cure unexposed areas within 7 days at ambient conditions. The gel fluoresces under UV light to allow inspection. HumiSeal® UV40 Gel is in full compliance with the RoHS Directive 2011/65/EU.

Conformal coatings can be successfully applied to substrates that have been cleaned prior to coating and also to substrates assembled with low residue, “no clean” assembly materials. Users should perform adequate testing to confirm compatibility between the conformal coating and their particular assembly materials, process conditions and cleanliness level. Please contact HumiSeal® for additional information.

You can use our Whatsapp support line to get information.

Syringe Application
HumiSeal® UV40 Gel is intended for automated needle dispensing, but may also be applied manually.

Rework
HumiSeal® UV40 Gel is a highly cross linked UV cured material. The cured film has a high degree of environmental and chemical resistance and will be more difficult to remove than traditional coatings. Thermal displacement and mechanical abrasion are suitable options for rework of HumiSeal® UV40 Gel.

Storage
HumiSeal® UV40 Gel is photosensitive. The product should not be exposed to direct sunlight or full spectrum fluorescent lighting. HumiSeal® UV40 Gel should be stored at 0 to 35°C, away from excessive heat, in tightly closed opaque containers. Prior to use, allow the product to equilibrate for 24 hours at room temperature. HumiSeal® UV40 Gel is a moisture curing material and care should be taken to protect process vessels and partial containers from moisture. Partial containers must be purged with a dry, inert gas such as dry air, nitrogen or argon, before closure, otherwise premature polymerization by atmospheric moisture will occur.

Density	1.06 g/cm³
Minimum Solids Content	95 %
Recommended Coating Thickness*	Up to 2.0 mm
Recommended UV Cure ^†	See TDS for Details
Shelf Life at Room Temperature, DOM	12 months
Dielectric Withstand Voltage, per MIL-I-46058C	>1500 votls
Dielectric Constant, at 1MHz and 25°C per ASTM D150-98	2.5
Dissipation Factor, at 1MHz and 25°C per ASTM D150-98	0.01
Insulation Resistance, per MIL-I-46058C	8.0 x 10¹⁴ ohms (800TΩ)
Moisture Insulation Resistance, per MIL-I-46058C	4.7 x 10¹⁰ ohms (47GΩ)